Notation mesurée et Mensurstrich

Adding a mensural time signature to your score

Pour ajouter une indication de mesure mensuraliste, il faut d'abord ajouter une indication de mesure conventionnelle, puis en modifier l'apparence en lui substituant le itsymbole mensuraliste approprié dans la boîte de dialogue des propriétés. Ces signes n'ont qu'une valeur d'affichage : il n'est pas possible de modifier le rapport de durées entre les valeurs de notes et l'indication de mesure conventionnelle sous-jacente reste inchangée.

Using mensural note symbols

[À ajouter]

• add from symbols palette, hide

Working with non-metered music

Early music, such as renaissance choral music, may be written without barlines or a time signature. This can be achieved in MuseScore as follows:

1. Set up the instruments or voices of the score in the usual way (See Setting up your score);

2. Hide the time signature;

3. in Format→Style→Score, check the box titled "Display note values across measure boundaries";

4. Right-click on a measure in the top staff and select Staff/Part properties;

5. Uncheck "Show barlines"; repeat this for each applicable staff (see note);

6. Click OK.

Note: In step 4 you can make the barlines invisible instead by selecting all and pressing V.

Note that the score still behaves as if measures are present. Measure properties can be applied if required.

Working with Mensurstrich

Mensurstrich is a form of modern notation of early music in which barlines are drawn between staves rather than across them:

Adding barlines between staves

1. Right click on the bottom staff of the intended mensurstrich system, and select Staff/Part properties. Uncheck "Show barlines".

2. Select the first (not the start!) barline for each of the remaining staves;

3. Check the "Span to next staff" box in the Barline section of the Properties panel;

4. Adjust "Span from" to set the position of the top of each barline;

5. Press Set as staff default;

Displaying note values across measure boundaries

1. From the menu bar, select Format→Style→Score;

2. Check "Display note values across measure boundaries".

See also